Product Description

2. It is recommended that the workpiece size be largerthan 100mm*100mm;

3. Suitable workpiece thickness: 140mm

4. Number and diameter of vacuum holes: 540 PCS of10mm

5. No sealing rope required;

6. Allows for partial complete milling of the workpiece;

7. Employs an aluminum replacement plate design, allowingfor multiple overhauls of the clamping surface;

8. Primarily used for high-precision machining ofnon-ferrous metals; not suitable for graphite, fiberglass, or similarmaterials;

9. Machining accuracy can reach 0.005mm;

10. Allow the use of cutting fluid;

11. The suction force on the workpiece is the same ineach vacuum hole.

12. High-precision vacuum table with three clampingworking surfaces;

Features and advantages:

A replaceable protective plate fullyprotects the vacuum table main unit from damage. The protective plate isreplaceable and is a low-cost consumable. The soft clamping surface of thevacuum table main unit can also be used as an emergency clamping surface. Thesoft clamping surface of the main unit can accommodate workpieces with poorflatness. Compared to traditional grid vacuum tables, this new automatic valvevacuum table can quickly complete clamping, and its advantages are even moreapparent for irregularly shaped workpieces. Localized after-sales service isprovided for Indian users.

FQA:

1.What is therecommended workpiece thickness for SOVAC vacuum tables?

Werecommend a workpiece thickness between 1mm and 40mm. For ultra-thinmaterials (0.3mm to 1mm), it is necessary to reduce the diameter of thevacuum orifices on the replaceable sacrificial plate.

2. What arethe size requirements for workpieces used with SOVAC vacuum tables? 

Generally, a minimumindividual workpiece size of 100mm x 100mm is recommended. For smallercomponents (e.g., 50mm x 50mm), we suggest using a "nesting"(tiling) strategy. Alternatively, auxiliary clamping methods such as adhesive wax or single-sided adhesive tape can be used. Please contact themanufacturer for specific operational techniques.

3. What arethe requirements for workpiece flatness and surface finish?

To ensure areliable vacuum seal, workpieces should typically have a surface roughness (Ra)within 3.2m and a flatness tolerance within 0.2mm.

4.  Yes. The PRISeries is compatible with both water-based and oil-based coolants. However,for the PRO and PRE Series, we strictly recommend water-basedcoolants; oil-based cutting fluids are not advised.

5. What isthe clamping accuracy (parallelism) of SOVAC vacuum tables?

SOVAC vacuumtables feature three distinct clamping interfaces:

·       Clamping accuracy of 0.04mm “ 0.07mm.

·       Clamping accuracy of 0.02mm.

·       When using a custom aluminum plate (manufactured bythe user based on our drawings), the clamping accuracy reaches 0.01mm.

6. Howshould the SOVAC vacuum table be cleaned?

 There are three recommended cleaning modes:

·       Applicable only for wetmachining. With the vacuum valve partially open, pour clean water over thesurface while the vacuum is active. The water will be sucked through theinternal structure to flush out debris. Note: This requires an AutomaticLiquid Separator in your vacuum line.

·       Blow compressed air in reverse through the vacuum port to clear internalpassages.

·       Use a white air-shroud to blow compressed air directly into the vacuum orificesfrom above.

·       For wet machining,perform all three modes daily. For dry machining, perform Modes 2 and 3after every workpiece cycle.